Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2006, Audio Asylum, all rights reserved ]
|
Home
/ FAQ
/ News Classifieds / Events |
madmanmike00's most hi-fi my money can buy System |
Welcome! To add your system, you must register. |
| Last Update: July 07, 2006 at 22:09:56 | IP Address: 4.159.215.145 |
| Amplifier: | poweramp inside sony str-6036-35w (internal preamp, tone controls and source switches bypassed,(for bass) usually up to 1500hz hitachi hma-3700 Lo-d 100w power amp even though it rarely gets much over 10watts(except really loud instances) for midrange usually around 1500hz up to about 5k and a regular sharp reciver from 80's for the tweeters 5k and up |
| Preamplifier (or None if Integrated): | pre-amps built into ev tapco cp-x 2 channel, 2-way electronic crossover with levelers for low and high (2 each channel) the sharp reciver still has its signal routed through the original circut. |
| Speakers: | Kenwood JL-770 acoustic air suspension 3-way 12'woofer 4-1/2'mid 2'tweeter, all cones with three amps directly controlling the speakers, original crossover still protects the tweeter (for now) rated at 70w rated max 140w(@8ohms) custom (slightly wider) cabinets |
| Sources: | |
| CD Player/DAC: | harmon kardon cdr-2 |
| Turntable/Phono Stage: | gerrard, bsr - shure n44c n44e n72b n55e v15typeIII n55e |
| Other Source(s): | fisher 8track player, sony tc-530 7-inch reel deck, teac 3300 10-inch reel deck both 1/4' 1/4 track but the teac can be converted with diffrent heads and capistan to run 1/4 tape half track at 15i.p.s. pioneer dual cassette, tv, vcr, mics, |
| Other Accessories/Room/Misc.: | |
| Speaker Cables/Interconnects: | push levers on the crossover which still protects my tweaters, typical blade connectors from amps to speakers silver sodder on the speaker tabs for the woofer and the mid signal cables are hosa wires with switchcraft ends 1/4' to rca except my sony which has 1/4' on one end and soddered to the poweramp module |
| Other (Power Conditioner, Racks etc.): | ev-tapco cp-x 2channel 2way electronic crossover to split signal by frequency range, adc equalizer im currently using only on 1k, 2k, and 4k, at about 12+ and dumping the rest (to midrange amp) and nothings there much below 1500hz |
| Tweaks: | play it flat, unless youre doing live shows the tone has been set, dont over-record |
| Room Size (LxWxH): | 30ft x 15ft x 8ft |
| Room Comments/Treatments: | left speaker shoots out along a wall, right speaker kinda shoots out along a half-wall if i had my way, a little wider, with 2 full walls and domed out behind the speakers (with subs in the floors)-----someday |
| Music Preferences and Comments: | |
| Music Used (Genre/Selections): | any good recording of decent music -im open to most diffrent types |
| System Goals/Comments: | more accurate sound reproduction |
| System Strengths: | accurate sound reproduction |
| System Weaknesses: | i could use 100 more amps and speakers, all diffrent kinds all solid-state at this point |
| Video/HT System: Separate | |
| TV/Projector: | picture tube tv |
| Processor/Receiver/Amplifiers: | archer-old analog surround, which only drives the rear speakers and shoots out the front signal to my stereo rig |
| Speakers (Center, Surrounds, Sub): | front kenwood-jl-770 acoustic air rear some crappy little pioneer speakers i got for free, no centerchannel subs |
| Sources (DVD/VCR): | vcr-mitsubishi dvd-emerson |
| Comments on HT System: | i dont have much in the way of this |
| Other Interests/Hobbies/Occupation: | cars |
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2006, Audio Asylum, all rights reserved ]